Hp Smart Array 6400 Drivers
NOTE: This is a list of supported hard disk drives (NOTE that some drives may be discontinued). Thank You for Submitting Your Review, ! Smart Array 6402/6404 Smart Array 5312 Smart Array 5302/5304 Introduction Date June/September 2003 April 2002 July 2000 SCSI Protocols Supported Ultra320, Ultra3, Ultra2 Ultra3, Ultra2 Ultra3, Ultra2, Wide-Ultra Maximum Channel Transfer Version:1.92 (C) (8 Apr 2004) Fixes Modified the installer for remote installation support. More about the author
The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Changed the SCSI ID detection algorithm for SCSI disk drive that unexpectedly changes its SCSI ID, in configurations involving duplex backplanes. Please submit your review for Smart Array 6400 Controller 1. Version:2.80 (C) (23 Jan 2008) Fixes Updated the component installer. If you have previously updated to version 2.80, another update is not needed.
This release of the Online ROM Flash Component for Windows, firmware version 2.32, does not require this updated Windows driver.For best performance, it is recommended to use HP ProLiant Smart Array Was the information on this page helpful? Driver version 126.96.36.199 and newer added support for the HP Smart Array 641/642 controllers. Enhanced performance for drive rebuilds and RAID 5 and RAID 6 (ADG) configurations.5.
Smart Array Cache Tracking monitors integrity of controller cache, allowing pre-failure preventative maintenance. Version:2.48 (A) (30 Aug 2005) Fixes Fixed an interrupt handling issue that can cause server reboot when using Microsoft Remote Installation Services (RIS).Updated the battery charging firmware to reduce the frequency and Enhancements Improved the flash update process. This new generation performance Smart Array controller again raises the standards of performance, introducing Double Data Rate (DDR) battery-backed write cache architecture and a new RAID engine.
Designed and tested with industry standard ProLiant Servers for greater reliability, this controller is ideal for workgroup, departmental, and enterprise servers. Version:2.26 (D) (18 Aug 2004) Fixes This revision D component corrects an issue which could cause a ProLiant server to blue screen when attempting an Online ROM Update to version 2.26 on To avoid notification during the POST routine, update any applicable hard disk drives before updating the Smart Array firmware. Dynamic Sector Repairing continually performs background surface scans on the hard disk drives during inactive periods and automatically re-maps bad sectors, ensuring data integrity.
Thank you! http://h20564.www2.hpe.com/hpsc/swd/public/detail?swItemId=MTX_9a1610ff1b8f49cdbff1ddc5ce Refer to Customer Advisory EM040728_CW01. Boot from the newly created Firmware Maintenance USB key. Version:2.84 (A) (15 Jul 2008) Fixes Implemented a stripe lock algorithm to avoid potential data write errors observed during rare instances of background surface analysis initialization and I/O writes occurring on Raid
Version:1.60 (B) (19 Mar 2004) Fixes Fixed an issue that might cause the controller not to boot.Fixed an issue with remote installation support in the component installer. have a peek at these guys Enhancements Added support for the MSA20 on ProLiant servers.Enabled event logging when the controller memory ECC error limit is exceeded for correctable ECC errors. Distributed Data Guarding (RAID 5): This allocates parity data across multiple drives and allows simultaneous write operations. Added support for the controller firmware to place a Monitoring and Performance stamp (M&P) on the disk drive, if it is missing from the drive.2.
Version 2.32 firmware for this controller family contains all enhancements and changes to date and does not require a Windows driver update prior to using the Online ROM Flash Component for This helps prevent the inconvenience of battery back write cache becoming temporarily disabled due to a required recharge following a battery firmware update. Updated the volume inquiry command for “Windows Server 2008” compliance. check over here Version:2.80 (C) (23 Jan 2008) Fixes Updated the component installer. If you have previously updated to version 2.80, another update is not needed.
Open Windows Explorer Right-click on Computer Select "Properties" Look for the "System" heading to find the "System type" A 64-bit system may shown as: "64-bit Operating System" Subscribe to driver and Note that your submission may not appear immediately on our site. Version:2.76 (B) (19 Jun 2007) Fixes Fixed an issue where the SA6404 would lock-up and cause Windows to blue-screen when installing or upgrading the Smart Array device driver in a server with
Was the information on this page helpful?
Version:2.58 (A) (7 Oct 2005) Fixes 1. Version:2.80(B) (25 Sep 2007) Fixes Upgrade Requirement:Recommended - HPE recommends users update to this version at their earliest convenience. End of content United StatesHewlett Packard Enterprise International Start of Country Selector content Select Your Country/Region and Language Click or use the tab key to select your country ArgentinaAustraliaBelgiqueBoliviaBrasilCanadaCanada-françaisChileColombiaDeutschlandEcuadorEspañaFranceIndiaIrelandItaliaMéxicoNederlandNew ZealandÖsterreichParaguayPerúPolskaPortugalPuerto RicoSchweizSouth Version 2.32 firmware for this controller family contains all enhancements and changes to date and does not require a Windows driver update prior to using the Online ROM Flash Component for
Fixed Array behavior to prevent unwanted device migrations by detecting conditions, where a SCSI disk drive unexpectedly changes its SCSI ID. 3. Note: Some software requires a valid warranty, current Hewlett Packard Enterprise support contract, or a license fee. If you have previously upgraded to version 2.62 firmware another update is not needed.2. Run Autorun from \_autorun\autorun_win.exe on the Firmware Maintenance CD from the USB key on a system Select the Firmware Update tab Click on the Install Firmware link to launch the HP
Blog Unsubscribe About Us Overview Contact Us Take our Site Survey Testimonials Copyright © 1996 - DriverGuide is an iCentric Corporation Company. Added an enhancement to allow an occasional SCSI command timeout without downshifting the SCSI bus to a lower speed.4. Click here to obtain the list of affected disk drive models. To use HP Smart Update Manager on the Firmware Maintenance CD version 7.50 and later: Place the Firmware Maintenance CD on a USB key using the HP USB Key Creator Utility.
All Rights Reserved Windows iOS Android Mac Enter to Search Popular Apps Popular Mac Apps AVG AntiVirus for Mac 5KPlayer Avast Free Mac Security VirtualDJ MacX YouTube Downloader VLC Media Player Follow HP Smart Update Manager steps to complete firmware update.nt